• Make sure that the SD card is inserted correctly.
• The address you enter has to match exactly the location in the map.
• If the postcode cannot be found try entering the place name instead.
• If the place name cannot be found try entering the postcode instead.
• Try using the map search function to find the location.

• Satellite signals are required for this product to function in Navigation Mode.
• There may be occasions within your home or building when the signal strength is limited and Navigation Mode may not be possible.
• This is quite normal of products of this type.
• Your car may have an athermic heat reflecting windscreen or windscreen heating that prevents the GPS receiver acquiring a valid signal. In these cases use the external antenna.

• This may be because there has been a new road opened that is not in the map's If when tracking the obvious route it looks like you are travelling across country then the road is not in the map's memory.

04: The unit is not responding properly when I touch the screen:

• You may need to re-calibrate the screen. To recalibrate touch the SETTING icon on the Open page then touch Calibrate and follow the instructions. See Ą°Screen CalibrationĄą and follow the instructions. See Ą°Screen CalibrationĄąon page 25.

• The software can sometimes take a few seconds to respond.
• If the unit is still not responding it can be reset.
• The Reset button is located next to the ON/OFF button as shown below.You will need to use a stylus to press the button.

• 27

• 12

• 3